ComAp InteliDrive FLX LITE, Manual, Page: 77 / 228

ID-FLX Lite Global Guide
77
Events
specification
Protection
type
Information on binary
output available
(see List of LBO on page
198)
Description
Sd AIO SD YES
Shutdown alarm configurable on the
input of plug-in.
Binary input Configurable YES
Configurable Warning/Shutdown
alarms on the inputs of ID-Lite.
Battery flat SD YES
If the controller switches off during
starting sequence due to bad battery
condition it doesn’t try to start again
and activates this protection.
Start failed SD YES Engine start failed.
RPM meas fail SD NO
At least one running condition was
detected (Poil>Starting POil or
energized D+) and do not appear
RPM>Starting RPM.
ParamFail NONE NO
Wrong checksum of parameters.
Happens typically after downloading
new firmware or changing of the
parameter. The controller stays in
INIT mode. Check all parameters,
write at least one new parameter.
Overspeed SD YES
The protection comes active if the
speed is greater than Overspeed
setpoint.
Underspeed SD YES
During starting of the engine when
the RPM reached the value of
Starting RPM setpoint the starter is
switched off and the speed of the
engine can drop under Start RPM
again. Then the Underspeed
protection becomes active.
Protection evaluation starts
5 seconds after reaching
StartingRPM.
EmergencyStop SD NO
If the input Emergency stop is
opened shutdown is immediately
activated.
PickupFault SD NO
Failure of magnetic pick-up sensor
for speed measurement.
Stop fail SD YES Engine stop failed.
WrnServiceTime WRN NO
The period for servicing is set by the
NextServTime setpoint. The