ID-FLX Lite Global Guide
70
Input
Analog input
Binary output
Load Switch
Setpoints
Load limit
Load CMP Input = Actual Load
Load CMP On = 2000
Load CMP Off = 2200
5.15.11 AUT mode: Engine regulation by RPM control – overview
Functions below can automatically change the engine RPM to keep value measured on controller (plug-in
module) Analog input (e.g. Pressure) on adjusted level.
Functions 3 = PI loop and 4 = Comparator with Hysteresis (CMPH) are available. The function setup is done by
corresponding setpoints in Regulator group. This group has one PI loop and one CMPH.
The PI function output is Speed request transmitted via J1939 or Analog output. Both functions can use
controller or plug-in IL-NT-AIO module Analog inputs.
Note:
In Regulator is input only from analog inputs or from RPM-BI3.
Condition
Speed request
Binary output
SpeedSwitch
OFF mode
= 0
MAN mode
Manual
In operation
AUT mode
Automatic by PI loop
In operation
Stop = Not Running
In operation
Sd protection
In operation
LBI R Reg Disable = 1
In operation
Summary of Contents for InteliDrive FLX LITE
