Chapter 4: To use the web interface
98-140012-H
To set up tracking and location reporting
88
To set up tracking and location reporting
You can set up the EXPLORER 710 to report to a server at certain time intervals. To set up
tracking, do as follows:
1. From the Control panel
gears
, select
Tracking and location reporting
.
2. To enable tracking of the EXPLORER 710, select
Enable tracking
.
3. Select the
Report type
.
•
Compressed
. Only latitude and longitude are reported.
•
Extended
. Apart from latitude and longitude, heading and altitude are also included.
•
ECEF
. The same information as Extended, but position and speed data are 3D (ECEF
coordinates).
4. Under
Server connection
, type in the following details:
•
Host IP address
: The IP address of the server that the EXPLORER 710 will report to.
•
Server port
: Port number on the server. Default number is 7474.
•
Client port
: Port number on the EXPLORER 710. Default number is 7475.
•
Encryption key
: A supplied 128 bit key which must match on both the client and
server side.
5. Under
APN
, select the source of the APN.
Note
HDR streaming is not available if you are using the Tracking function.
