Chapter 4: To use the web interface
98-140012-H
Optional: To set up cellular network for data
111
7. If required, select
gearsalt
on the tile to set or change the name or the APN of your cellular
connection. For details, see the next section.
When the connection is established, an “M” on the signal bar in the top right corner indicates
that it is a cellular (Modem) connection, and the tile shows details about the connection.
The data connection is automatically established when set up correctly, so you cannot start
and stop the cellular connection from the tile as you can with the BGAN connections.
You can now access the Internet through the cellular network from a device connected to the
EXPLORER 710. Note that you cannot use the BGAN network as long as EXPLORER Cellular
Modem is selected.
To change the name or the APN for your cellular connection
Do as follows:
1. Select
gearsalt
on the tile with the cellular connection.
2. Type in the new name for your connection.
3. Type in the name of the APN you are going to use for your cellular connection.
4. Click
Save
.
Note
You may have to enter a PIN before you can use the cellular network, see
the SIM PIN in the web interface on page 53
Note
You cannot make calls nor send SMS messages on the cellular network through the
EXPLORER 710. Only data connection is possible over the cellular network. You can
still send and receive SMS messages using the BGAN mobile number of the terminal
(if the terminal is pointed and connected to the CS domain in the BGAN network).
