TORQUE CONVERTER
Driven Clutch
2001 Pioneer 1200 Gasoline Vehicle Maintenance and Service Manual Page 17-15
17
6. Place the clutch assembly in a press and position the cam press tool (CCI 101809101) on the cam as
shown (Figure 17-19, Page 17-15).
7. Hold the fixed face assembly (3) and rotate the moveable face assembly (1) one-third turn clockwise,
then press the cam (2) onto the fixed face assembly (Figure 17-19, Page 17-15).
8. Install the retaining ring (2) (Figure 17-16, Page 17-12). See following NOTE.
NOTE: The retaining ring can be reused if the O.D. does not exceed 1.607 inches (40.82 mm). Otherwise it
must be replaced with a new ring (CCI 1014080).
9. While holding onto the cam, tap the end of the fixed face shaft lightly with a plastic mallet until the cam
seats against the retaining ring. See following CAUTION.
∆ CAUTION
• Do not use a metal hammer to tap the fixed face hub. A metal hammer will damage the shaft.
DRIVEN CLUTCH INSTALLATION
1. To install the driven clutch, reverse the removal procedure. Before tightening the center bolt (11) to 14
ft-lb (19.0 N·m), make sure the mounting washer (12) is installed between the center bolt and the clutch
(yellow side facing out) (Figure 17-16, Page 17-12).
Figure 17-19 Cam Press Tool
CAM PRESS TOOL
1
2
3
