BODY AND TRIM
Seat
2001 Pioneer 1200 Gasoline Vehicle Maintenance and Service Manual Page 4-5
4
FRONT FENDER REMOVAL
1. Remove front body (6) as instructed in Front Body Removal on page 4-3 (Figure 4-1, Page 4-4).
2. Pull back floor mat to access rivets securing front fender (9). Drill out two rivets (10) and remove four
washers (11) at bottom of front fender.
3. Remove two screws (12) securing fender to fender support and remove front fender from vehicle.
FRONT FENDER INSTALLATION
1. Reverse removal procedure to install front fender. Tighten screws securing fender to fender support to
50 in-lb (5.7 N·m).
FRONT BODY INSTALLATION
1. Place front body (6) onto vehicle and connect the light wiring harness to the headlight assemblies (Fig-
2. Secure front body to dashboard with five screws (3) and washers (4). Tighten screws to 45 in-lb (5.1
N·m).
3. Install five caps (1).
4. Secure front body to fenders with eight Tuflok fasteners (7). To install the Tuflok fasteners, insert into
hole and push the head in.
SEAT
Read WARNING and CAUTION on page 4-1.
To preserve seat appearance clean regularly with mild soap or detergent applied with a sponge or soft cloth.
Use a soft bristle brush to clean areas that are especially soiled. Use the following guidelines:
Light Soiling – A solution of 10% liquid dish soap and warm water applied with a soft, damp cloth is rec-
ommended. A soft bristle brush may be used if necessary. Wipe off any residue with a water dampened
cloth.
For Difficult Stains – Dampen a soft, white cloth with a solution of 10% household bleach (sodium
hypochlorite) and 90% water. Rub gently to remove stain, then rinse with a water dampened cloth to
remove bleach concentration.
For More Difficult Stains – Perform previous procedure using full-strength bleach, or allow bleach to
puddle on affected area for approximately 30 minutes. Rinse with a water dampened cloth to remove any
remaining bleach concentration.
∆ CAUTION
• To prevent damage to the vehicle when removing difficult stains or heavy soiling, remove the seat
from the vehicle first.
SEAT REMOVAL
1. Pull seat forward and lift up to remove from seat support (1).
