TORQUE CONVERTER
Drive Clutch
2001 Pioneer 1200 Gasoline Vehicle Maintenance and Service Manual Page 17-11
17
15. Install remaining two buttons.
16. Install a number 10-24 button retaining screw with flat washer through each button and into the rib.
Tighten the screws to 34 in-lb (3.8 N·m) (Figure 17-9, Page 17-8).
17. Install the thrust washer (11) onto the moveable face assembly (Figure 17-5, Page 17-6).
18. Install the hub assembly (1) on the moveable face assembly and align the match marks made before
disassembling the clutch. Press the hub assembly on by hand (Figure 17-5, Page 17-6).
Figure 17-14 Install White Washers
Figure 17-15 Correct Orientation of Drive Button Take-up Spring
Pin should protrude an equal amount
on both sides.
Install white
washers on
each side
of pin.
DRIVE BUTTON TAKE UP
SPRING PROPERLY INSTALLED