![background image](http://html.mh-extra.com/html/club-car/2008-export-battery-charger/2008-export-battery-charger_maintenance-service-manual_2626717119.webp)
EXPORT IQ PLUS CHARGER (EXTERNAL)
Test Procedures
2008 Export Battery Charger Maintenance and Service Manual
Page 5-23
5
4. Using a multimeter, set for 200 ohms, place the red (+) probe into the center terminal in the end of the
AC cord. Test for continuity on each of the flat blades and on the round pin of the AC plug. The tester
should indicate continuity on the ground pin only. If any other reading is obtained, the AC cord has failed
and must be replaced.
AC Charger Receptacle
1. Disconnect the AC cord from the AC receptacle (on front of battery charger) and the incoming AC outlet.
Disconnect the battery charger from the vehicle.
2. Disconnect black wire from charger relay terminal 4 (4)
(Figure 5-18, Page 5-24 and Figure 5-6,
Page 5-9)
.
Figure 5-16 AC Plug and AC Charger Receptacle Continuity Test
Figure 5-17 AC Cord Test
2m
20
m
200
m
2k
200
200
200
200
20
2
200
m
500
20k
200k
2000
k
1000
OFF
WAVETEK
5XL
V
V
V
A
!
!
COM
200nA
MAX
1000 ---
750V
FUSED
200 OHM SETTING
4
8
2