EXPORT POWERDRIVE BATTERY CHARGER (EXTERNAL)
Charger Repairs
2008 Export Battery Charger Maintenance and Service Manual
Page 3-33
3
AMMETER
See General Warning, Section 1, Page 1-1. See additional WARNING on page 3-1.
Ammeter Removal
1. Disconnect AC cord from the wall outlet and DC plug from the vehicle receptacle.
See WARNING on
page 3-30.
2. Remove the charger cover.
3. Using two wrenches to prevent the posts from turning, disconnect the DC cord black wire (5) and buss
bar (3) from the ammeter
(Figure 3-29, Page 3-33)
.
4. Remove the two nuts (2) that secure the ammeter to the charger face.
5. Remove the ammeter from the face of the charger.
Ammeter Installation
1. Place the ammeter in position in the charger face
(Figure 3-29, Page 3-33)
.
2. Install the nuts (2) and tighten until ammeter is firmly secured.
3. Connect the DC cord black wire (5) to the left (as viewed from inside the charger) post of the ammeter.
4. Connect the buss bar (3) from the fuse link to the right post of the ammeter. Place flat washers on both
sides of the buss bar.
5. Thread nuts (4) onto both posts of the ammeter until just past finger tight. While holding the inside nut,
tighten the outside nut 1/4 turn.
See following CAUTION.
CAUT ION
• Do not allow ammeter post to rotate as the nut is tightened. Rotation of the post could result
in a damaged ammeter.
6. Install the charger cover.
7. Plug the charger into the vehicle and check ammeter for proper operation.
Figure 3-29 Ammeter
3
4
1
2
5