EXPORT POWERDRIVE CHARGER (ONBOARD)
Onboard Charger Removal and Installation
Page 4-36
2008 Export Battery Charger Maintenance and Service Manual
4
Onboard Charger Installation
1. Installation is reverse of removal.
2. Tighten hardware securing the black DC cord wire to 23 in-lb (2.6 N·m) and the red DC cord wire to 144
in-lb (16 N·m).
3. Install four bolts (21), flat washers (22), lock washers (23) and nuts (24) securing charger to chassis and
tighten to 108 in-lb (12 N·m)
(Figure 4-28, Page 4-35)
.
4. Connect battery cables, positive (+) cable first, and tighten to 144 in-lb (16 N·m).
PRECEDENT VEHICLES
Onboard Charger Removal
1. Disconnect the batteries as instructed.
See General Warning, Section 1, Page 1-1.
2. Disconnect the charger DC cord at the three pin connector (1)
(Figure 4-30, Page 4-37)
.
3. Remove four bolts (2), flat washers (3), lock washers (4) and nuts (5) securing charger to chassis.
4. Lift charger assembly from vehicle.
Figure 4-29 Charger DC Cord Black Wire and Blue
Wire – DS Villager 4
20
19
17
18
