![background image](http://html.mh-extra.com/html/club-car/2008-export-battery-charger/2008-export-battery-charger_maintenance-service-manual_2626717101.webp)
EXPORT IQ PLUS CHARGER (EXTERNAL)
External Charger Installation and Operation
2008 Export Battery Charger Maintenance and Service Manual
Page 5-5
5
ý
WARNING
• Do not operate the charger if it has received a sharp blow, was dropped, or otherwise
damaged in any way.
• Have worn, cut, or damaged power cords or wires replaced immediately.
• Do not block or cover the charger ventilation slots. The slots provide ventilation and prevent
the charger from overheating.
• Do not allow clothing, blankets, or other material to cover the charger.
• Do not allow the charger to operate for more than 30 minutes at 19 or more amperes.
• Install surge arrestors on incoming AC power lines. Surge arrestors will help protect electrical
components in the charger and on the vehicle from all but direct or close lightening strikes.
ý
CAUTION
• Be sure to check the batteries and charger monthly to maintain correct battery water level and
ensure the charger is operating correctly during storage.
NOTE:
Charger operation instructions in the language of the user should be printed on or permanently
affixed to the top of the charger. If these instructions are not found on the charger, contact your
Club Car representative.
AC POWER CONNECTION
The AC line to which the charger is to be connected must be of the proper AC input voltage for the charger
and must be capable of supplying sufficient current.
See Section 2 – Charger Identification and Specifica-
tions.
If the battery charger is equipped with a multi-position switch for variable AC input voltage, the switch
must be set for the correct voltage before the AC cord is connected
(Figure 5-3, Page 5-6)
.
See following
CAUTION.
CAUT ION
• Failure to set the AC input voltage selector switch to the correct voltage could result in
damage to the battery charger or batteries.
NOTE:
Make sure that the AC cord provided with your charger has the proper AC plug for your location. If
it does not, contact your Club Car representative to obtain the proper cord or plug.
With charger DC cord disconnected, connect the power supply cord to an AC supply within the acceptable
voltage range.
See Section 2 – Charger Identification and Specifications.
To reduce the risk of electric shock, the battery charger must be grounded. The charger is equipped with an
AC electric cord with an equipment-grounding conductor and a grounding type plug. The AC plug must be
connected to an appropriate receptacle that is properly installed and grounded in accordance with all applica-
ble national and local electrical codes and regulations.
The use of an extension cord with the charger should be avoided. If an extension cord must be used, use a
three-conductor no. 12 AWG (American Wire Gauge) or no. 14 SWG (British Standard Wire Gauge), heavy-
duty cord with ground, properly wired and in good electrical condition. Keep it as short as possible (no more
than 12 feet (3.7 m)). Place all cords so they will not be stepped on, tripped over, or otherwise subject to dam-
age or stress.
Ensure that the charger ventilation slots are unobstructed and that there is adequate ventilation.