![background image](http://html.mh-extra.com/html/club-car/2008-export-battery-charger/2008-export-battery-charger_maintenance-service-manual_2626717088.webp)
EXPORT POWERDRIVE CHARGER (ONBOARD)
Charger Repairs
Page 4-30
2008 Export Battery Charger Maintenance and Service Manual
4
5. Thread nuts (4) onto both posts of ammeter until just past finger tight. While holding the inside nut, tighten
the outside nut (4) 1/4 turn.
See following CAUTION.
CAUT ION
• Do not allow ammeter post to rotate as the nut is tightened. Rotation of the post could result
in a damaged ammeter.
6. Install charger cover and install charger in vehicle.
See Onboard Charger Installation on page 4-36.
7. Check charger for proper operation.
FUSE LINK
See General Warning, Section 1, Page 1-1.
Fuse Link Removal
1. Disconnect the DC cord, the AC cord from the wall outlet, and remove the battery charger from the vehi-
cle.
See Onboard Charger Removal on page 4-35.
See WARNING on page 4-26.
2. Remove the charger cover.
3. Remove both black secondary coil transformer wires and the buss bar (3) from the back of the fuse link
assembly
(Figure 4-25, Page 4-29)
.
4. Remove screws from the front of the charger and remove the fuse link assembly.
Fuse Link Installation
1. Place clear plastic cover over fuse assembly and install mounting screws from front of charger face. The
center branch of the fuse assembly should be in the upper left corner when viewed from the front of the
charger.
2. Install the buss bar (3) over the center branch of the fuse assembly and ammeter post
(Figure 4-25,
Page 4-29)
. Tighten to 22 in-lb (2.5 N·m).
3. Install a secondary coil transformer wire (black) onto one of the two remaining terminals on the back of
the fuse assembly. Install the remaining secondary coil transformer wire (black) onto the remaining ter-
minal. Tighten to 22 in-lb (2.5 N·m).
4. Install the charger cover and install the charger in the vehicle.
See Onboard Charger Installation on
page 4-36.
5. Check charger for proper operation.
CHARGER RELAY
See General Warning, Section 1, Page 1-1.
Charger Relay Removal
1. Disconnect the DC cord, the AC cord from the wall outlet, and remove the battery charger from the vehi-
cle.
See Onboard Charger Removal on page 4-35.
See WARNING on page 4-26.
2. Remove the charger cover.
3. Disconnect all wires from the relay
(Figure 4-26, Page 4-31)
.
4. Remove the two screws and nuts attaching relay to mounting bracket.
5. Remove the relay.