S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
22-66
Cisco MDS 9000 Family Command Reference
OL-18089-01, Cisco MDS NX-OS Release 4.x
Chapter 22 Show Commands
show dmm ip-peer
show dmm ip-peer
To display information about the IP peers the DMM interface is connected to, use the
show dmm ip-peer
command in EXEC mode.
show dmm ip-peer
Syntax Description
This command has no arguments or keywords.
Defaults
None.
Command Modes
EXEC mode.
Command History
Usage Guidelines
You must connect to an SSM on your switch to execute DMM
show
commands. Use the
show module
command to determine the slot number of an SSM on your switch. Use the
attach module
slot
command
to connect to the SSM.
Examples
The following example displays DMM IP peer information:
switch#
attach module 3
Attaching to module 3 ...
To exit type 'exit', to abort type '$.'
Bad terminal type: "ansi". Will assume vt100.
module-3#
show dmm ip-peer
Cisco DMM IP Peer Table
-------------------------------------------------------------------
No Type SD IP Address TCP State
-------------------------------------------------------------------
1 CONFIG_STATION 23 10.100.2.1 DOWN
2 PEER_SSM 22 10.100.1.20 UP
3 CONFIG_STATION 19 10.100.2.1 DOWN
Release
Modification
3.2(1)
This command was introduced.
