Christie Solaria One, User Manual

Page: 95 / 136

Solaria One User Manual 13-17
020-100841-02 Rev. 1 (11-2012)
13.7.4 Add a NAS
Your network-attached storage (NAS) device must be configured to use the Network File System (NFS)
protocol. Christie recommends that you select the Dynamic Host Configuration Protocol (DHCP) for the NAS
device. However, if the NAS device uses a static IP address, see
Configure NAS Ethernet Port IP Addresses on
page 13-18 .
1. Verify the NAS device is connected to one of the gigabit Ethernet ports on the Christie IMB labeled NAS-
1 or NAS-2 .
2. Tap Menu > Christie IMB > System .
3. Tap Storage .
4. Tap Add NAS .
5. Tap Primary if this is your primary NAS device.
6. Tap Yes .
7. Complete the information fields for the NAS device.
8. Tap
Refresh Share Names .
9. Select a share in the Share list.
10. Tap OK .
11. Tap Save .
12. Tap OK .
13.7.5 Edit NAS Settings
1. Tap Menu > Christie IMB > System .
2. Tap Storage .
3. Tap a NAS device in the NAS list.
4. Edit the NAS settings.
5. Tap
OK .
6. Tap Save .
13.7.6 Test NAS Connectivity
1. Tap Menu > Christie IMB > System .
2. Tap Storage .
3. Tap a NAS device in the NAS list.
4. Tap Test Connectivity .
5. Tap OK .
6. Tap Cancel .
13.7.7 Test NAS Performance
When testing NAS performance, use test content that is large enough to allow the test to run for 2 minutes or
longer.