Christie Solaria One, User Manual

Page: 30 / 136

1-16 Solaria One User Manual
020-100841-02 Rev. 1 (11-2012)
2. Loosen the threaded bolt on the ground lug on the AC receptacle on the rear corner of the projector.
3. Remove 15 mm of insulated covering from both ends of the protected earth wire.
4. Insert a bare end of the protected earth wire into the hole on the top of the ground lug so it is beneath the
threaded bolt.
5. Tighten the threaded bolt to 50 in-lb.
6. Connect the other bare end of the protected earth wire to the building ground.
7. Connect one end of the projector power cord to the AC receptacle on the lower-left rear corner of the
projector and then connect the other end of the power cord to an AC receptacle.
If you are using an Uninterrupted Power Supply (UPS) to power the main electronics, move the AC switch
to A + B and connect the power cord provided with the UPS to the B outlet.
1.12 Turn the Projector On
DO NOT attempt to turn the projector on if the AC supply is not within the
specified voltage range. See
Projector Specifications on page A-1
for power requirements
.
1. Ensure the circuit breaker for the projector is ON.
2. On the touch panel controller (TPC), tap and hold the green power icon.
WARNING