Christie Solaria One, User Manual

Page: 34 / 136

1-20 Solaria One User Manual
020-100841-02 Rev. 1 (11-2012)
2. Display a RGB-12bit-Full Screen White test pattern and center the image:
a. Tap the Test Pattern icon (
)
in the task bar.
b. Tap All Test Patterns .
c. Tap RGB-12bit-Full Screen White .
d. Hold a sheet of translucent paper in front of the lens of the bottom projector.
e. Turn the vertical and horizontal knobs on the front of the projector clockwise and counterclockwise to
center the light created by the projector on the screen.
3. Display the DC2K Framing2 test pattern:
a. On the touch panel controller (TPC), tap the Test Pattern icon (
)
in the task bar.
b. Tap All Test Patterns .
c. Tap DC2K Framing2 .
4. Turn the vertical and horizontal knobs on the front of the projector clockwise and counterclockwise to
refine the position of the test pattern on the screen.
5. Turn the zoom adjustment ring on the lens to fit the image to your screen and focus the test pattern details.
When your adjustment is complete, the words and lines in the test pattern should be distinguishable
uniformly across the screen and there should not be any sections that are out of focus.
6. With the framing test pattern displayed, re-check projector leveling so the top edge of the image is parallel
to the top edge of the screen.
7. Display a full white test pattern:
a. On the TPC, tap the Test Pattern icon (
)
in the task bar.
b. Tap All Test Patterns .
c. Tap RGB-12bit-Full Screen White .
8. If the test pattern is focused and centered on the screen you do not need to complete further image
adjustment. If the image is not focused and centered on the screen, complete one of these procedures:
a. See
Correct Keystone Effect on page 2-1 if the image appears distorted and resembles a trapezoid.
b. See Correct Vignetting on page 2-3 or Align the Lamp on page 1-18 if the image is brighter at the cen-
ter than it is at the sides.
c. See Fold Mirror Adjustment on page 2-6 if a corner or edge of an image is missing.
d. See Adjust Vertical Boresight Angle on page 2-3 if the image cannot be focused uniformly on the
screen with a focus adjustment.
e. See Adjust Horizontal Boresight on page 2-4 if a large horizontal angular offset to the screen is
required.