Christie Solaria One, User Manual

Page: 25 / 136

Solaria One User Manual 1-11
020-100841-02 Rev. 1 (11-2012)
8. Loosen the cathode clamp with the 5 mm hex key attached to the lamp door.
9. Install the lamp:
Handle the lamp by the cathode/anode end shafts only, never the glass. DO
NOT over-tighten. DO NOT stress the glass in any way. Check leads. Ensure the anode (+)
lead between the lamp and igniter is well away from any projector metal, such as the
reflector or fire wall.
a. Remove the tape from the ends of the protective case.
b. Remove the plastic packing material from the lamp.
c. Remove the cathode nut from the lamp before removing it from the case.
d. Hold the anode end of the new lamp in your left hand and angle it up through the hole in the back of
the reflector assembly. Insert your right index and middle finger through the back of the reflector and
guide the lamp onto the cathode clamp. Be careful not to hit the lamp against the reflector.
e. Thread on and hand-tighten the cathode nut. Ensure the smooth portion of the nut is against the
cathode clamp.
f. Tighten the cathode clamp (4) with a hex key.
g. Align the ring terminal on the anode wire (2) with the mounting position ensuring the crimped side of
the wire is facing out. Tighten the anode screw.
NOTE:
Route anode lead away from nearby metal
surfaces.
10. Close the lamp access door and tighten the 2 thumbscrews.
1 Anode Terminal
2 Anode Wire
3 Reflector
4 Cathode Screw
5 Cathode Nut
6 Cathode Clamp
2
3
4
5
6
1