Solaria One User Manual
1-19
020-100841-02 Rev. 1 (11-2012)
a. Locate the Y axis adjustment label on the operator side of the projector.
b. Insert a 5 mm hex driver through the louvers at an angle below the Y axis adjustment label until it is
firmly seated on the Y axis adjustment screw.
c. Turn the screw clockwise or counterclockwise until the value in the
Intensity
field peaks and then
reduces.
d. Remove the hex driver and repeat steps a to c to adjust the Z and X axis.
7. Complete a fine lamp adjustment:
a. Locate the Y axis adjustment label on the operator side of the projector.
b. Insert a 5 mm hex driver through the louvers until it is firmly seated on the Y axis adjustment screw.
c. Turn the screw slowly clockwise or counterclockwise until you determine the highest value.
d. Remove the hex driver and repeat steps a to c to adjust the Z and X axis.
8. Verify the value in the
Intensity
field is greater or equal to the number you recorded in step 4. If value is
lower, repeat steps 6 and Step 7.
1.19
Adjust the Image to Fit Your Screen
This procedure must be completed before you complete a boresight adjustment.
1. Verify the projector is properly positioned relative to the screen. See
Position the Projector on page 1-4
.
Summary of Contents for Solaria One
