Christie Solaria One, User Manual

Page: 117 / 136

Solaria One User Manual 15-5
020-100841-02 Rev. 1 (11-2012)
7. Align the ring terminal on the anode wire (2) with the mounting position ensuring the crimped side of the
wire is facing out. Tighten the anode screw.
NOTE:
Route anode lead away from nearby metal surfaces.
8. Close the lamp access door and tighten the 2 thumbscrews.
9. Close the firewall door and tighten the 2 thumbscrews.
10. Close and lock the rear access door.
NOTE:
Ensure the hex key is placed back into its holder before
closing the rear access door .
11. Connect the projector to AC power and then turn the projector on.
12. Tap
Menu > Advanced Setup > Lamp Change Wizard .
13. Tap Next .
14. Complete these fields:
15. Tap Save .
16. Tap Next .
17. Align the lamp. See Align the Lamp on page 1-18 .
15.5 Replace the Card Cage Filter
Use only high efficiency Christie approved filters. Never operate the projector
without the filter installed. Always discard used air filters.
You should check the condition of the card cage air filter
monthly. Replace the card cage air filter sooner if you are
operating the projector in a dusty or dirty environment. The
filter is located on the left side of the projector behind the air
filter cover.
1. Loosen the 2 captive screws on the bottom of the filter
cover.
2. Pull the cover out and down.
3. Slide the air filter out and discard. Insert the new air filter
with the airflow indicator facing toward the projector.
4. Install the air filter cover by inserting the 2 bottom tabs and then pushing the door closed.
5. Tighten the 2 captive screws.
Field Description
Type The lamp type.
Serial Number The lamp serial number.
Reason for Change The reason the lamp was changed.
Lamp Expiry (Hours) The number of hours the lamp can operate before replacement. This field
is auto-populated.
Hours Used The number of hours the lamp has operated before installation.