Christie Solaria One, User Manual

Page: 123 / 136

Solaria One User Manual 16-3
020-100841-02 Rev. 1 (11-2012)
Image Appears Vertically Stretched or Squeezed into Center of Screen
Open the Source File Setup window and verify the resolution and aspect ratio settings. Open the Screen File
Setup window and verify the lens factor settings
Inaccurate Display Colors
Adjust the color, tint, color space, and color temperature settings of your input source. Tap Menu > Channel
Setup . Tap Config 1 in the left pane and verify the correct value is selected in the PCF list. Tap Config 2 in the
left pane and verify the correct value is selected in the Color Space field.
Display is Not Rectangular
• Verify the projector is level and the lens surface and screen are parallel to one another.
• Adjust the vertical offset of the lens mount with the vertical offset knob.
• Tap
Menu > Advanced Setup > Screen File Setup and verify the settings for the screen file are correct.
Display is Noisy
• Adjust the input source pixel tracking, phase, and filter.
• Verify the cables connecting the input device to the projector meet the minimum requirements.
• Add signal amplification or conditioning if the distance between the input device and the projector exceeds
25 feet.
Display has Suddenly Frozen
Turn off the projector and unplug the power cord from the power source. Plug the projector power cord into a
power source and turn the projector on.
The Projector is On, but Alternate Content Does Not Display
• Make sure the lens cover is removed from the lens.
• Make sure the lamp is on.
• Make sure the douser is open.
• Tap on the main TPC screen. If the lamp does not strike, see Lamp Functionality on page 16-1 .
• Tap Menu > Channel Setup . Verify the correct channel is selected and the settings are correct.
• Ensure an active source is connected properly. Check the cable connections and make sure the alternative
source is selected.
• Verify you can select test patterns. If you can, check your source connections again.
The Display is Jittery or Unstable
• Verify that the input device is connected properly. If the input device is not connected properly, the projector
repeatedly attempts to display an image.
• The horizontal or vertical scan frequency of the input signal may be out of range for the projector.
• The sync signal may be inadequate. Correct the source problem.
Portions of the Display are Cut Off or Warped to the Opposite Edge
If you have resized the image, adjust the resizing settings until the entire image is visible and centered.