Four-Port 10/100 Ethernet NIC
Check Point IP690 Security Platform Installation Guide
49
Ethernet NIC Connectors and Cables
The Ethernet connectors on the four-port 10/100 Ethernet NICs are RJ-45 connectors. Use a
straight-through cable to connect the NIC to a 10-Mbps or 100-Mbps hub or switch or a
crossover cable to connect directly to a host.
Use ANSI TIA/EIA-568-A/B compliant (Cat 5 or Cat 5e) unshielded twisted pair cable. You can
order appropriate adapter cables separately from a cable vendor of your choice.
Caution
Cables that connect to the Ethernet NIC must be ANSI TIA/EIA-568-A/B compliant (Cat
5 or Cat 5e) to prevent potential data loss.
Figure 12
shows the pin assignments for the RJ-45 cable. The connector is numbered from right
to left, with the copper tabs facing up and toward you.
Figure 12 Output Connector for the Ethernet Cable
Figure 13
shows the pin assignments for the RJ-45 cross-over cable.
00270
Pin
Assignment
1
TX +
2
TX -
3
RX +
4
5
6
RX -
7
8
8
1
Summary of Contents for IP690 - Flash Based Sys
