Check Point IP690 - Flash Based Sys, Installation Manual

Page: 24 / 118

1
Overview
24 Check Point IP690 Security Platform Installation Guide
Site Requirements, Warnings, and Cautions
Before you install a Check Point IP690 security platform, ensure that your computer room or
wiring closet conforms to the environmental specifications listed in
Appendix A, “Technical
Specifications.”
Warning
Excessive electromagnetic interference (EMI) can occur if you use controls, make
performance adjustments, or follow procedures that are not described in this document.
Warning
To reduce the risk of fire, electric shock, and injury when you use telephone equipment,
follow basic safety precautions. Do not use the product near water.
Warning
On Check Point IP690 security platforms intended for shipment outside of the United States,
the cord set might be optional. If a cord set is not provided, use a power cord rated at 10A,
250V, maximum 15 feet long, made of HAR cordage and IEC fittings approved by the
country of end use.
Caution
Risk of explosion if battery is replaced by an incorrect type. Replace the battery only
with the same or equivalent type that the manufacturer recommends. Dispose of used
batteries according to the manufacturer's instructions.
Caution
Do not block any of the ventilation holes on the appliance. The components might
overheat and become damaged.
Software Requirements
The Check Point IP690 security platform supports the following operating system and
applications as of the publication date for this guide:
„
IPSO v4.2 or later operating system
„
Check Point VPN-1/FW-1 firewall application
For information about updates to the software requirements or additional applications that have
become available since this guide was published, see the Check Point Support Center at
http://
support.checkpoint.com/ .