Check Point IP690 - Flash Based Sys, Installation Manual, Page: 79 / 118

Replacing the Compact Flash Memory Card
Check Point IP690 Security Platform Installation Guide 79
To replace your compact flash
1.
Use Check Point Network Voyager or the command-line interface (CLI) to perform an
orderly shutdown of the IP690 appliance.
For information about how to access Network Voyager and the related reference materials,
see
“Using Check Point Network Voyager” on page 38.
2. Turn off the power to the IP690 appliance.
Note
Make sure you turn off power on the power supplies.
3. Loosen the two front panel retaining screws.
4.
Slowly slide the chassis tray assembly forward, taking care to prevent damaging
components, press the release tab on the right side of the assembly, and completely remove
the chassis tray assembly to expose the motherboard components.
5. Place the chassis tray assembly on a table top.
00581
SLOT 1 SLOT 2 SLOT 3 SLOT 4
1
2
3
4
IP690
RESET
AUX CONSOLE
Chassis tray assembly retaining screws
SL OT
1
SL OT
2
SL OT
3
SL OT
4
1
2
3 4
IP690
RES
ET
AUX
CON
SOL
E
00597