Check Point IP690 - Flash Based Sys, Installation Manual, Page: 77 / 118

Check Point IP690 Security Platform Installation Guide 77
7
Installing and Replacing Components
Other than Network Interface Cards
(NICs) and Accelerated Data Path
(ADP) Services Modules
This chapter provides information about how to install or replace orderable parts other than
network interface cards (NICs) and Accelerated Data Path (ADP) services modules in your
Check Point IP690 appliance. The following topics are covered:
„
Replacing the Compact Flash Memory Card
„
Installing and Using a PC Card
„
Installing a Hard-Disk Drive
„
Replacing a Check Point Encryption Accelerator Card
„
Replacing a Fan Unit
„
Replacing a Power Supply
„
Replacing the Battery
For information about how to add or replace NICs, see Chapter 4, “Installing and Replacing
Network Interface Cards.”
For information about how to add or replace ADP modules, see Chapter 6, “Installing, Using,
and Replacing ADP Services Modules.”
You should have a working knowledge of networking equipment before you attempt to service
an IP690 appliance. Limit service of the appliance to the procedures described in this chapter.
Note
To protect the IP690 appliance and the memory modules from electrostatic discharge
damage, make sure you are properly grounded before you touch these components. Use a
grounding wrist strap and follow the instructions provided with the wrist strap before you
handle the components or open the appliance.