Check Point IP690 - Flash Based Sys, Installation Manual

Page: 95 / 118

Replacing the Battery
Check Point IP690 Security Platform Installation Guide 95
the CLI, see the CLI Reference Guide. For more information about Network Voyager, see the
Check Point Network Voyager Reference Guide or use the Network Voyager inline help.
To monitor the IP690 appliance power supplies by using Check Point Network
Voyager
1.
Log on to the IP690 appliance with Network Voyager.
2. Click Monitor.
3. Click Hardware Monitoring > System Status.
To the right of the Power Supply link, the status indicator is green for normal and red for
fault.
4. For more detailed information about the power supply status, click Power Supply.
Replacing the Battery
To replace the battery, you need the following:
„
The appropriate Check Point battery replacement kit for your appliance
„
Physical access to the appliance
„
A Phillips-head screwdriver
„
A grounding wrist strap
„
(Optional) Safety glasses
Caution
Risk of explosion if battery is replaced by an incorrect type. Replace the battery only
with the same or equivalent type that the manufacturer recommends. Dispose of used
batteries according to the manufacturer's instructions.Make certain that you are
properly grounded when you handle components internal to the appliance to protect
against electrostatic discharge damage to the appliance. Use the grounding strap
included in the battery replacement kit.
To install the battery, perform the following tasks:
1. Use Check Point Network Voyager or the command-line interface (CLI) to perform an
orderly shutdown of the IP690.
For information about how to access Network Voyager and the related reference materials,
see
“Using Check Point Network Voyager” on page 38.
2. Turn off the power to the IP690 appliance.
3. Loosen the front panel retaining screws.