Check Point IP690 - Flash Based Sys, Installation Manual

Page: 89 / 118

Replacing a Check Point Encryption Accelerator Card
Check Point IP690 Security Platform Installation Guide 89
6. Loosen the four retaining screws and remove the card by pulling up from the right side of
the card above the interface connectors.
Caution
Do not use the PMC connectors located at the front of the motherboard for the
encryption accelerator card. Those connectors are for NICs and ADP modules.
7. Position the three male PMC connectors on the card over the three female PMC connectors
on the motherboard.
The two sets of connectors should be aligned with each other. The four screw holes and four
standoffs should also be aligned with each other.
8. Push down on the right side of the card above the interface connectors until it is properly
seated on the motherboard.
00517.1
00518.1