Check Point IP690 - Flash Based Sys, Installation Manual

Page: 87 / 118

Replacing a Check Point Encryption Accelerator Card
Check Point IP690 Security Platform Installation Guide 87
Caution
To help guard against electrostatic discharge damage, make sure you are properly
grounded by using a grounding wrist strap and following the instructions provided with
the wrist strap before you handle the components or open the appliance.
Note
You do not need to manually disconnect power for this procedure. If the power supply
switches at the rear of the appliance are difficult to reach, you can safely disconnect power
when you remove the chassis tray assembly from the front of the appliance. Any servicing of
the appliance should be completed with the chassis tray assembly fully removed from the
appliance.
To replace the encryption accelerator card
1.
Use Check Point Network Voyager or the command-line interface (CLI) to perform an
orderly shutdown of the IP690.
For information about how to access Network Voyager and the related reference materials,
see
“Using Check Point Network Voyager” on page 38.
2. Turn off the power to the IP690 appliance.
3. Loosen the two chassis tray assembly retaining screws.
00581
SLOT 1 SLOT 2 SLOT 3 SLOT 4
1
2
3
4
IP690
RESET
AUX CONSOLE
Chassis tray assembly retaining screws