Check Point IP690 - Flash Based Sys, Installation Manual

Page: 94 / 118

7
Installing and Replacing Components Other than Network Interface Cards (NICs) and Accelerated Data Path
94 Check Point IP690 Security Platform Installation Guide
6. Grasp the handle and release lever as shown in the following figure, and use the handle to
firmly pull the power supply out of the chassis.
7. Insert the new power supply into the empty bay until the release lever latches.
8. Replace the grounding cable if being used.
9. Plug the power cord into the new power supply.
10. Turn on the power.
Monitoring the IP690 Appliance Power Supply
You can monitor the status of the IP690 appliance power supplies with Check Point Network
Voyager. Similarly, you can also use the command-line interface (CLI). For information about
00588
00598