Check Point IP690 - Flash Based Sys, Installation Manual

Page: 91 / 118

Replacing a Fan Unit
Check Point IP690 Security Platform Installation Guide 91
To enable IKE acceleration
1.
From the Network Voyager home page, click Security and Access Configuration, then click
IKE Acceleration.
For information about how to access Network Voyager and the related reference materials,
see
“Using Check Point Network Voyager” on page 38.
2. On the IKE Acceleration page, click Register the module.
3. Click Apply.
The PKCS#11 token that enables IKE acceleration is registered with the Check Point software
on your appliance. After you register the module, you must install the Check Point security
policy on the firewall for the encryption accelerator card to perform IKE acceleration.
Replacing a Fan Unit
The appliance fan unit is a single unit made up of four individual fans to provide the air flow
required to maintain a proper operating temperature. The fan unit can provide proper airflow for
a short time even if an individual fan fails.
Before you replace a fan unit, you must first turn off power to the appliance.
Before You Begin
To replace a fan unit, you need:
„
Physical access to the IP690 appliance
„
Replacement fan unit kit
„
A Phillips-head screwdriver
Caution
Components inside the appliance can overheat if they are not cooled even for a short
period of time. If you are replacing a failed fan unit, you must completely remove power
to the appliance.
To replace a fan unit
1.
Use Check Point Network Voyager or the command-line interface (CLI) to perform an
orderly shutdown of the IP690.
For information about how to access Network Voyager and the related reference materials,
see
“Using Check Point Network Voyager” on page 38.
2. Turn off power to the IP690 appliance.