Case Communications syncro 1496, Reference Manual

Page: 48 / 192

Factory Configuration 4
Operation : PSTN, V.32bis.
Rates : Primary 14400, fallback 12000.
V.24 : DTR conforms to ITU-T 108/2 (call disconnected on loss of
DTR).
Commands : AT via the command port. V.25bis Byte via DTE port.
Typical Use : The modem operates as a 2-wire, full duplex 14400 bps
dialup modem. Calls are initiated in V.25bis Byte
synchronous format via the main data channel, and the
command port is active for AT commands
.
Configuration Screen F4
F36 Communication Format 14400 V32bis *V2 Command Mode V25 BYTE
X6 Result Codes ALL *W0 DSR Control NORMAL
&B0 Busy Out Control DISABLED ”A0 Leased Line Mode ORIGINATE
&G0 Guard tone OFF ”D0 Restore on DTR DISABLED
&L0 Line Mode 2W PSTN ”E1 Security Control ENABLED
&Q3 Operation Mode SYNC MANUAL DIAL ”N3 Remote Logon ORIG & ANS
&R0 RTS/CTS Delay 0mS ”Q0 Quality Mon LL DISABLED
&S1 Switches ENABLED /B1 Carrier CONSTANT
&X0 Timing Source INTERNAL /C1 Cable Equaliser ENABLED
%B0 Pin 23 Fallback DISABLED /D0 DCD Threshold –43dB
%E7 Remote Control USER & LINE /F35 Fallback Format 12000 V32bis
%F0 Fallback DISABLED /G1 T/2 Equaliser ENABLED
%Q1 Interface Control ENABLED /Q0 Quality Mon PSTN DISABLED
*B1 S10 DCD Timeout 40 Secs /R1 S26 Base RTS/CTS X 1mS
*M0 Data Monitor OFF /S1 Response EXTENDED
*R0 RTS Clamp OFF /T4 Test Pattern MARKS/ERR INJ
*T1 DCD Timeout LOSS /W1 S37 Mon. Timeout 0 Mins
*L0 Dial backup DISABLED /Y2 Re-Training AUTO RETRAIN
X450-310851 Issue 2 4-12 Rev.1