Case Communications syncro 1496, Reference Manual

Page: 124 / 192

*T Carrier Timeouts
While in PSTN operation, your modem will immediately disconnect
if the remote modem disconnects, and your modem detects dial tone
from your local exchange. However, should the remote modem not
disconnect, then
*T allows you to set a timeout which will cause a
disconnection on loss of carrier.
*T0
Loss-of-carrier timeout disabled.
*T1
Loss-of-carrier timeout enabled. Default.
Register S10 determines the length of the loss-of-carrier timeout.
S10 is measured in increments of 1 second or 0.1 of a second,
depending on the setting of the
*B command.
/T Test Pattern
This command enables you to select whether the error injection
facility is enabled or not.
/T0 MARKS pattern.
/T4
MARKS pattern with error injection.
V Verbose Response Codes
This command determines how the modem communicates with the
user, i.e. whether response codes are expressed as words or numeric
code. Referred to as verbose/terse, or long/short form. Response
codes are listed with the
X command.
V0 Selects numeric (terse) codes.
V1
Selects word (verbose) codes. Default.
Numeric codes are followed by a single
<CR>
. Word codes are
followed by <CR><LF> .
X450-310851 Issue 2 8-22 Rev.0