Case Communications syncro 1496, Reference Manual

Page: 42 / 192

4.1.3 Factory Configuration Specifications
Factory Configuration 0
Operation : Leased line, V.32bis, answer mode.
Rates : Primary 14400, fallback 12000.
V.24 : Normal.
Commands : AT via the command port.
Typical Use : The modem is set to answer mode and must always be
used with an originate modem (e.g. factory configuration
1) at the remote end of the link.
Configuration Screen F0
F36 Communication Format 14400 V32bis *V0 Command Mode AT
X6 Result Codes ALL *W0 DSR Control NORMAL
&B0 Busy Out Control DISABLED ”A1 Leased Line Mode ANSWER
&G0 Guard tone OFF ”D0 Restore on DTR DISABLED
&L1 Line Mode 2W LEASE LINE ”E1 Security Control ENABLED
&Q1 Operation Mode SYNC ASYNC DIAL ”N3 Remote Logon ORIG & ANS
&R0 RTS/CTS Delay 0mS ”Q0 Quality Mon LL DISABLED
&S1 Switches ENABLED /B1 Carrier CONSTANT
&X0 Timing Source INTERNAL /C1 Cable Equaliser ENABLED
%B0 Pin 23 Fallback DISABLED /D1 DCD Threshold –33dB
%E7 Remote Control USER & LINE /F35 Fallback Format 12000 V32bis
%F0 Fallback DISABLED /G1 T/2 Equaliser ENABLED
%Q0 Interface Control DISABLED /Q0 Quality Mon PSTN DISABLED
*B1 S10 DCD Timeout 40 Secs /R1 S26 Base RTS/CTS X 1mS
*M0 Data Monitor OFF /S1 Response EXTENDED
*R0 RTS Clamp OFF /T4 Test Pattern MARKS/ERR INJ
*T1 DCD Timeout LOSS /W1 S37 Mon. Timeout 0 Mins
*L5 Dial backup 2-WIRE ON /Y2 Re-Training AUTO RETRAIN
TIMEOUT
X450-310851 Issue 2 4-6 Rev.0