Case Communications syncro 1496, Reference Manual

Page: 74 / 192

To log-on to the remote modem:
1. Ensure that both modems involved in the remote log-on have ''N and
''E
set correctly. (The default in all factory and user configurations is
''N3 and ''E1 , which will allow correct operation.)
2. Load an appropriate PSTN configuration into the modem being used
for the PSTN connection (see Chapter 4 for a description of available
configurations).
3. Dial into the remote modem using
AT''Xnnn
where
nnn
is the
telephone number of the remote modem's LINE 3 (PSTN 1).
4. To confirm the remote log-on, both the local and remote modem's
command ports will display the message
REMOTE CONTROL
GRANTED
.
Once the remote log-on has been granted, all commands entered on the
command port of the local modem are transmitted to the remote modem.
All responses from the remote modem are sent back to the local modem's
command port terminal.
To log-off from the remote modem:
Either enter AT''K just to log-off, or enter AT''J to log-off and initiate a dial
backup attempt. In this case the dial backup number must have been
stored in memory location N8.
Note: Analogue loopback is not available when the remote log-on facility is
in use. Use of the
A/ sequence is not supported either.
X450-310851 Issue 2 5-8 Rev.0