Case Communications syncro 1496, Reference Manual

Page: 123 / 192

/S Extra Response Codes
This command is used to select whether response codes preceded by
/ will be issued or not. (A table of these codes is given with the
X
command.)
/S0 Extra responses off.
/S1 Extra responses on. Default.
''S
Display Analogue Parameters
This command displays a set of analogue parameters relating to the
local modem and line (see Section 7.5).
&T
Select Modem Test Operation
This command is used to select a test operation. See Chapter 7. It
is used in conjunction with S-register timer S18, which determines
the length of time that a test is performed.
&T0
Stops test currently in progress.
&T1 Selects Local Analogue Loopback without self-test.
&T4 Enables the local modem to run a Remote Digital
Loopback when requested by the remote modem.
Default.
&T5 Prohibits the local modem from running a Remote
Digital Loopback when requested by the remote
modem.
&T6
Initiates Remote Digital Loopback without self-
test (ITU-T V.54 Loop 2).
&T7 Initiates Remote Digital Loopback with self-test
(ITU-T V.54 loop 2).
&T8 Initiates Local Analogue Loopback with self-test.
&T99 Inject an error.
X450-310851 Issue 2 8-21 Rev.1