Case Communications syncro 1496, Reference Manual

Page: 49 / 192

Factory Configuration 5
Operation : PSTN, V.32bis.
Rates : Primary 14400, fallback 12000.
V.24 : DTR conforms to ITU-T 108/2 (call disconnected on loss of
DTR).
Commands : AT via the command port, V.25bis HDLC via the DTE
port.
Typical Use : The modem operates as a 2-wire, full duplex 14400 bps
dialup modem. Calls are initiated in V.25bis HDLC
synchronous format via the main data channel, and the
command port is active for AT commands.
Configuration Screen F5
F36 Communication Format 14400 V32bis *V3 Command Mode V25 HDLC
X6 Result Codes ALL *W0 DSR Control NORMAL
&B0 Busy Out Control DISABLED ”A0 Leased Line Mode ORIGINATE
&G0 Guard tone OFF ”D0 Restore on DTR DISABLED
&L0 Line Mode 2W PSTN ”E1 Security Control ENABLED
&Q3 Operation Mode SYNC MANUAL DIAL ”N3 Remote Logon ORIG & ANS
&R0 RTS/CTS Delay 0mS ”Q0 Quality Mon LL DISABLED
&S1 Switches ENABLED /B1 Carrier CONSTANT
&X0 Timing Source INTERNAL /C1 Cable Equaliser ENABLED
%B0 Pin 23 Fallback DISABLED /D0 DCD Threshold –43dB
%E7 Remote Control USER & LINE /F35 Fallback Format 12000 V32bis
%F0 Fallback DISABLED /G1 T/2 Equaliser ENABLED
%Q1 Interface Control ENABLED /Q0 Quality Mon PSTN DISABLED
*B1 S10 DCD Timeout 40 Secs /R1 S26 Base RTS/CTS X 1mS
*M0 Data Monitor OFF /S1 Response EXTENDED
*R0 RTS Clamp OFF /T4 Test Pattern MARKS/ERR INJ
*T1 DCD Timeout LOSS /W1 S37 Mon. Timeout 0 Mins
*L0 Dial backup DISABLED /Y2 Re-Training AUTO RETRAIN
X450-310851 Issue 2 4-13 Rev.1