Case Communications syncro 1496, Reference Manual

Page: 114 / 192

''J Terminate Remote Log-On and Initiate Dial Backup
This command logs off from a remote modem (previously logged-on
by the
''X
command), and initiates a dial backup connection.
K Call Timer
This command will access the call timer within your modem.
The response will show the current, or previous, call time in
minutes and seconds.
''K Terminate Remote Log-On
This command logs off from a remote modem (previously logged-on
to by the
''X
command).
&L Line Type
This command is used to set your modem to PSTN or to 2- or 4-wire
leased line operation.
&L0
Enable 2-wire PSTN operation.
&L1 Enable 2-wire leased line operation.
&L3 Enable 4-wire leased line operation.
When you select leased line operation, the connection to the line is
made via the cord labelled
LINE 1
. When you select PSTN operation,
connection is via a cord that you must connect to the
LINE 3
socket.
*L
Dial Backup Facility
This command is used to enable or disable the dial backup facility.
Available in single line (2-wire) format.
*L Disable dial backup.
*L1 Manual dial backup.
*L5
2-wire dial backup on loss of carrier.
*L13 2-wire dial backup on loss of carrier, with automatic
restoral to leased line.
''L
Manual Revert to Leased Line
Issuing this command will cause the modem to disconnect its PSTN
backup line and revert to the leased line.
X450-310851 Issue 2 8-12 Rev.0