Canon imageRUNNER ADVANCE C3330 Series, Troubleshooting Manual, Page: 33 / 200

By changing the setting value, make the duration of initial rotation longer to raise the temperature of Fixing Film edge on using
Thin paper (52 to 63gsm).
[Caution] By changing the setting value to "2", it takes extra 60 seconds to start printing on using Thin paper (52 to 63gsm).
5) Output the image having shown the symptom, and check that the symptom does not occur. If the symptom no longer occurs,
the work is completed.
If the improvement of the symptom is not enough, go to step 6).
6) Fixing alignment adjustment is performed.
6-1) Open the Right Door, and lift up the Right Door [1], slide the Right Door Guide (Left) [2] and Right Door Guide (Right) [3] in
the direction in the figure below to fully open it.
6-2) Grasp the light-blue handle [1], and remove the Fixing Unit [2].
6-3) Open the Front Door, and remove the Front Door [1] while lifting it up slightly and pushing the claw [2].
- 1 Claw [2]
- 2 Bosses [3]
6-4) Remove the Drum Unit (Bk).
[Caution]
- If you perform the work while in sleep mode or when the power was turned OFF while in sleep mode, the Primary Transfer Roller
will not be disengaged.
When removing the Drum Unit (Bk), be sure to do so after returning the machine to a standby state.
- Since there is a risk of damaging the Photosensitive Drum, do not touch the surface.
28