Canon imageRUNNER ADVANCE C3330 Series, Troubleshooting Manual, Page: 110 / 200

2) Install the waste toner gear holder by fitting the boss holes[c] on the lower part of the waste toner gear holder with the bosses[C]
of the main unit.
[Caution] Fig.[A] shows the state where the bosses are fitted deeply [a] and normally installed. Fig.[B] shows the state where the
bosses are fitted shallowly [b] and installed insufficiently.
3) Check that the above-mentioned three bosses and claws are fitted normally and the side of the waste toner gear holder and
the flat surface of the mounting part are set parallel to each other.
However, if the new type part mentioned as the factory measure is attached to the main unit, the symptom would not occur even
if the precaution for inserting a yellow developing assembly is not taken account.
1. INTERMEDIATE GUIDE ASSEMBLY (FM1-D186-010)
2. WASTE TONER GEAR HOLDER ASS'Y (FM1-D187-010)
[Countermeasure cut-in serial numbers in factory]
Model Serial number
iR-ADV C3330i US 120V QTV04719
iR-ADV C3325i US 120V QTW07094
iR-ADV C3330i LTN 230V RJQ00702
iR-ADV C3325i LTN 230V RJR00758
iR-ADV C3330i EUR 230V QTF05191
iR-ADV C3325i EUR 230V QTS10220
iR-ADV C3320i EUR 230V QTT09627
iR-ADV C3320 EUR 230V QTU00964
iR-ADV C3330 AS 230V QTZ01584
iR-ADV C3325 AS 230V QUB01102
iR-ADV C3320 AS 230V QUC02326
105