Canon imageRUNNER ADVANCE C3330 Series, Troubleshooting Manual, Page: 107 / 200

4) Remove the swing gear [a]. Press the core in the center to separate the core [b] from the gear [c].
5) Apply a grain of rice size of the grease (MOLYKOTE EM-50L GREASE) to the 2 ribs [a] at the middle of the core. Then insert
the core into the gear to assemble the swing gear.
[Caution]
- When inserting the core into the gear, be careful not to deform the spring [b].
- Be sure not to apply the grease to the inner face [c] and the end face [d] of the long hole in the core, and to the boss [e].
6) Position the boss [a] of the swing gear to a point between the mark-off lines [b] on the metal plate. Then insert the swing gear.
7) Install the parts by reversing the procedure from step 3).
[Caution]
- If the sheet for preventing pinching of the cable is attached to the Fixing Drive Unit and the sheet is once removed, be sure not
to reuse the sheet because its adhesive force is low.
- In order to prevent pinching of the cable, route the cable while making sure that the cable is not loosened. Especially, make
sure that the cable is not out of the claw at the point where the sheet was initially attached.
For details, refer to Service Information No. F00355 "Routing of the cable when installing Fixing Drive Assembly."
8) During initial rotation after the power is turned ON or after a button on the touch panel is pressed, check that the symptom
does not occur.
If the symptom does not improve, check other causes.
[Additional part]
HY9-0007 MOLYKOTE EM-50L GREASE
102