Canon imagePASS-P2, Service Manual

Page: 61 / 92

6. Read the instructions in the windows, and click Next.
7. Switch off the Host Machine and confirm that the imagePASS is cut off. (see “Starting, shutting down, rebooting, and restarting
the imagePASS” on page 9 ).
8. Remove all external cables from the imagePASS, except the power cable and interface cable.
NOTE:
Be sure to leave the power cable connected between the imagePASS and the power outlet.
9. Flip both of the imagePASS service switches to the Service (ON) position.
1 2
Figure 31: Flipping the imagePASS service switches
No. Item
1 Flip the service switches from Normal (OFF) position...
2 ...to Service mode (ON) position.
10. Connect the Ethernet cable between the imagePASS network port and an Ethernet port on the Windows computer.
NOTE:
• Ethernet port: Connected to the imagePASS upper part (for the user network).
• Ethernet cable: Use crossover cable
11. Switch on the Host Machine and confirm that the imagePASS becomes ON.
Wait approximately 15 seconds for the imagePASS to start up and show 00 on the LED display.
4. INSTALLING SYSTEM SOFTWARE
56