Canon DADF-Q1, Service Manual

Page: 87 / 156

Chapter 3
3-9
3.3.5 Belt Motor Unit
3.3.5.1 Removing the Front Cover
0011-8251
1) Remove the front cover [1].
-Three screws [2] (remove)
-One screw [3] (loosen)
F-3-58
F-3-59
F-3-60
3.3.5.2 Removing the Main Cover
0011-8132
1) Open the upper cover, and insert a screwdriver from above the hook; then,
remove the two hooks [1].
F-3-61
2) Free the hook of the pickup assembly cover [2] from the right stay; then,
detach it while paying attention to the hooks on the front and rear side
plates.
F-3-62
3) When you have removed the ADF controller cover, disconnect the con-
nector [3] of the ADF controller PCB; then, remove the screw [4], and re-
move the grounding wire [5]. Free the harness from the wire saddle [6],
and detach the other saddle [7].
F-3-63
4) Remove the four screws [1], and detach the main cover [2].
The main cover is fitted with the original tray [3], and cables are connected
to it. Take extra care when removing it not to damage the cables.
F-3-64
[1]
[1]
[2]
Hooks
Push.
Freed.
[5]
[7]
[4]
[6]
[3]
[1]
[1]
[1]
[1]
[3]
[2]