Canon CLC5100 Series, Manual

Page: 193 / 290

Chapter 5
5-63
10 M19 (duplex feed motor) Operates for 10 sec, stops for 3 sec, and then operates
for 10 sec and stops.
Its operation stops in response to a press on the Stop
key.
11 M15 (polishing/oil removing
motor)
Rotates CCW/CW for 10 sec, stops for 3 sec, rotates
CCW for 10, and then stops.
Its operation stops in response to a press on the Stop
key.
12 M24Y, M24M, M24C, M24Bk
(primary charging wire cleaner
motor)
Cleans by a single backandforth trip.
13 Fixing web motor Operates for 5 sec and then stops.
14 M12 (Transfer belt cleaning
motor)
Operates for 1 sec and then stops.
15 M2 (mirror slant correction motor
for Y)
M2 (mirror slant correction motor for Y)
16 M3 (mirror ratio correction motor
for Y)
Rotates CW for a single full turn, rotates
CCW for a single turn, and then stops.
17 M5 (mirror slant correction motor
for C)
Rotates CW for a single full turn, rotates
CCW for a single turn, and then stops.
18 M6 (mirror ratio correction motor
for C)
Rotates CW for a single full turn, rotates
CCW for a single turn, and then stops.
19 M7 (mirror slant correction motor
for Bk)
Rotates CW for a single full turn, rotates
CCW for a single turn, and then stops.
20 M8 (mirror ratio correction motor
for Bk)
Rotates CW for a single full turn, rotates
CCW for a single turn, and then stops.
21 M13 (transfer belt swing motor) Rotates CW for a single full turn, rotates
CCW for a single turn, and then stops.
22 M23 (duplexing paper jogging
guide motor)
Executes home position detection, stops for 3 sec,
moves to A4 position, stops for 3 sec, moves to B4
position, stops for 3 sec, moves to A4R position, stops
for 3 sec, moves to B5R position, stops for 3 sec, and
then moves to home position.
23 M28 (duplex reversal motor) Rotates for drawin operation for 3 sec, rotates for
feedout operation for 3 sec, stops for 1 sec, rotates for
drawin for 3 sec, rotates for feedout for 3 sec, and
then stops.
Details of MTR
No
.
Motor Control