Canon CLC5100 Series, Manual

Page: 172 / 290

Chapter 5
ޓ
5-42
<HVFS> ADJUST > HVFS
This mode will prove effective when correcting image distortion under each item in question.
T-5-28
SPS21 Effective in special paper 2 mode and, in addition, when copying on a
onesided copy.
SPS22 Effective in special paper 2 mode and, in addition, when copying on
the 2nd side of a twosided copy.
SPS31 Effective in special paper 3 mode and, in addition, when copying on a
onesided copy or on the 1st side of a twosided copy.
SPS32 In special paper 3 mode and, in addition, when copying on the 2nd side
of a twosided copy.
ADJUST > HVFS
Sub item Description
Settings range: 5 to +5
ޓ
Standard: 0
ޓ
unit: 25 uA
Record any new values on the service data sheet
(excluding BODY (ºC), BODY (%), BODY (g), ZONE A/B/C, STMTMD and << ZONE
A >>)
BODY (ºC)
BODY (%)
BODY (g)
Indicates the machine internal temperature (ºC), internal humidity (%),
internal humidity absolute value (g) measured by the environment
sensor.
Same as the reading under 'DISPLAY > ANALOG'
FSOFST Adjusts the transfer highvoltage output.
ZONE A/B/C Indicates the machine internal humidity absolute value (g) in the three
ranges of A through C.
STMTMD Adjust the highvoltage output for size of STMT.
Setting range: 1 to +9
ޓ
Standard: 0
If stray toner occurs for STMT size images before fixing, increase the
setting (so that the highvoltage output will increase) to limit the
problem.
However, keep in mind that too high a setting will cause the paper to
stick to the guide before fixing, turning into a jam.
<< ZONE A >> Indicates the zone in which the setting shown is effective.
ADJUST > HVSP
Sub item Description