Canon CLC5100 Series, Manual

Page: 70 / 290

Chapter 2
2-18
12) Likewise, adjust the following volumes:
For Bk/Y laser unit,
Execute the following in service mode, and use
VR7:'FUNC>LASER>266P00'
Execute the following in service mode, and use
VR8:'FUNC>LASER> 266PFF'
For C/M laser unit,
Execute the following in service mode, and use
VR7:'FUNC>LASER>200P00'
Execute the following in service mode, and use
VR8:'FUNC>LASER>200PFF'
13) Press the Reset key to end service mode.
14) Turn off the power switch.
15) Remove the laser power checker, and install the
inlet cover.
2.4.6 Laser Focus
Adjustment
0002-0382
CLC5100 / CLC4000
1) Check to make sure that the marking [1] on the lens
assembly matches the marking [2] on the lens
mount (standard position).
ޓ
F-2-34
ޓ
If the unit is not in standard position, loosen the
locking nut [3], and turn the lens assembly until the
distance to the end [4] of the lens assembly is 27.3
±0.2 mm, i.e., where the markings match.
ޓ
F-2-35
ޓ
2) Perform focusing adjustments by turning the lens
assembly once again according to the values
recorded on the label. For instance, if the value is
"+2/8," turn the lens assembly in the positive
direction (counterclockwise when viewing from the
end of the lens assembly) over two notches.
ޓ
F-2-36
ޓ
[1]
[2]
±
[4]
Feed length label