Canon CLC5100 Series, Manual

Page: 108 / 290

Chapter 3
3-10
0101
Multifeeder lifter motor (M1; faulty)
DC controller PCB (faulty)
The upper lifter sensor (PS2) does not turn ON within 6
sec after the multifeeder lifter motor (M1) has turned
ON.
0102
The lower lifter sensor (PS3) does not turn ON within 6
sec after the multifeeder lifter motor (M1) has turned
ON.
0103
The error detection circuit of the DC controller PCB
detects overcurrent in the multifeeder lifter drive circuit.
E041
0001
The deck lifter motor (M2) is faulty.
The deck lifter lower linit switch (SW2) is
faulty.
The DC controller PCB is faulty.
When the lift action of the paper deck is not completed
within 60 secs.
E044
0001
The paper width set for the cassette or the
multifeeder is wrong.
The slide resistor is faulty.
Wrong paper width for multifeeder
0002 Wrong paper width for upper cassette
0003 Wrong paper width for lower cassette
E050
0001
Duplex paper jogging guide motor (M23;
faulty)
Duplex paper jogging guide home position
sensor (PS29; faulty)
DC controller PCB (faulty)
The duplexing unit stacking guide home position sensor
(PS29) does not turn ON within 4 sec after the duplex
paper jogging guide motor (M23) has turned ON.
0002
The duplex paper jogging guide home position sensor
(PS29) remains ON for 1 sec or more after the duplexing
unit stacking guide motor (M23) has turned ON.
E061
Potential Control Fault
highorder 2 digits
xx=00:common error xx=01:Y xx=02:M xx=03:C xx=04:BK
xx01
Potential measurement unit (faulty)
DC controller PCB (faulty)
Primary/Preprimary charging assembly
(faulty)
Preexposure lamp (faulty)
The difference between VD1 measured during the 1st
rotation and VD1 measured during the 2nd rotation is 30
V or more.
xx02
The difference between VD2 measured during the 1st
rotation and VD2 measured during the 2nd rotation is 30
V or more.
xx03
The difference between VL1 measured during the 1st
rotation and VL1 measured during the 2nd rotation is 30
V or more.
xx04
The difference between VL2 measured during the 1st
rotation and VL2 measured during the 2nd rotation is 30
V or more.
Code Cause
Description