Canon CLC5100 Series, Manual

Page: 80 / 290

Chapter 2
2-28
T-2-6
2.7.5 Initializing the RAM
on the Reader Controller
PCB
0002-5905
CLC5100 / CLC4000
1) Record the settings of user mode.
2) Execute 'FUNC>RCON>RAMCLR' in service
mode. (The power switch will automatically turn
off.)
3) Turn on the power switch.
4) Execute 'FUNC>CCD>AUTOADJ' in service
mode. (about 8 min)
5) If a projector is installed, execute 'FUNC>PROJ
ADJ>PROJCCD' in service mode.
6) Enter any new user mode settings and the settings
recorded in B of the service label. (If you have
changed any other service mode settings related to
the reader controller, enter such settings.)
2.7.6 When Replacing the
Image Position
Correction CCD Unit
0002-0451
CLC5100 / CLC4000
1) After replacing the image position correction CCD
unit, execute 'FUNC>INSTALL (2nd
screen)>REG APER' in service mode. Thereafter,
be sure to turn off and on the power switch to
correct the image position.
2.7.7 When Replacing the
Paper Thickness Sensor
0002-0456
CLC5100 / CLC4000
1) Check the settings (A through E) recorded on the
label attached to the paper thickness sensor you are
replacing, and record them under 'SNSRRNK' on
the service label. At this time, you need not perform
step 3) and the subsequent steps if the settings are
the same as the settings under 'FUNC>P
THICK>SNSRRNK' of service mode.
2) Replace the power thickness sensor.
3) Enter the settings you recorded on the service label
in step 1) under 'FUNC>PTHICK> SNSRRNK' in
service mode. (Each press on 'SNSRRNK' toggles
the settings A through E.)
4) Check to make sure that the values of 'PTH1' and
'PTH2' are identical to the values recorded on the
service label; if different, enter the correct values
using 'FUNCDC CON (5/5)>PTH1/2' in service
mode.
5) End service mode.
ADJUST Settings on PASCAL screen
Settings on FEEDADJ
screen
Settings on ENVSET screen
Settings on HVTR C/M/Y/K
screen
Settings on HVSP screen
Settings on HVFS screen
Settings on HVEL screen
FUNC Settings on DCCON screen
Settings on PUPTMG
screen
Settings on PTHICK screen
Settings on IMGREG screen
Settings on FUSER screen
OPTION Settings on POPT screen
(except ONSET)