Bosch Rexroth Nexo, Manual

Page: 91 / 279

3 608 870 A47
Tightening Technology |
Bosch Rexroth AG 91
/279
Nexo cordless Wi-Fi nutrunner
| 3 608 870 A47/2019-10
MID 0014 Tightening program subscription selected
Target torque The target torque is multiplied by 100 and then sent as a whole number
(rounded to two decimals).
The value consists of six ASCII characters.
ID
07
2
Value range
000000 – 999999
Presetting
-
Example:
Target torque
250,00
Value
025000
6
Minimum angle The value consists of five ASCII characters.
ID
08
2
Value range
00000 – 99999
Presetting
-
Example:
Minimum angle
30
Value
00030
5
Maximum angle The value consists of five ASCII characters.
ID
09
2
Value range
00000 – 99999
Presetting
-
Example:
Maximum angle
45
Value
00045
5
Target angle The target angle is output in degrees.
The value consists of five ASCII characters.
ID
10
2
Value range
00000 – 99999
Presetting
-
Example:
Target angle
40
Value
00040
5
Data length revision 001
84
Table 7–13: MID 0013 revision 001
Parameter Comments Bytes
Sent by:
superordinate computer
A message (tightening program selected, MID 0015) is sent to the superior computer each time a new tightening
program is selected. This message is also sent as a direct answer to the activation message, after the response
(command accepted, MID 0005) has been sent.
Note:
Sends the appropriate data to the superordinate controller each time the tightening program is changed.
Revision:
001
Data field:
is empty, 0 bytes
Possible responses MID Error no. Comment
Command accepted 0005 –
Command error 0004 13 Subscription for tightening program selection
already available