Bizerba GLM-I, Instruction Manual, Page: 353 / 505

Instruction manual GLM-I Troubleshooting
38.019.129.001 en 351
25
25.2.4 Messages: Scale
Message Cause Rectification
"Scale not connected" No scale is connected when
the device is switched on.
Connect scale.
"Scale does not give weight
value"
The scale does not provide
any weight values after initi-
alization. This can be
caused by a cable becoming
loose during operation.
Check cables.
Connect scale.
"Scale outside range" The weight value is smaller
than the negative zeroset-
ting limit (-1% of MAX).
Clear the weighing belt.
Press <Reset>.
"Scale outs. zero range
when activated"
When switched on the scale
is not within the ± 10% of
MAX.
Clear the weighing belt.
Press <Reset>.
"Zero tracking not possible" The scales cannot carry out
an automatic zero point cor-
rection. The weight value of
the unloaded scale is not
within ± 3e.
Check that the weighing belt
is empty.
Press <Reset>.
"Zero tracking not possible,
provide package gap."
The scale should not be loa-
ded briefly for an automatic
zero point correction.
Create a gap in the pack-
ages.
When the weighing belt is
empty, the scales automati-
cally correct the zero point.
"Zero tracking not possible,
stop automat, set scale to
zero"
The scale could not perform
a zero point correction within
a second time interval.
Stop device.
If the weight belt is empty,
press <Reset>.
"Min. weight error" The weight value is smaller
than the minimum value pre-
set in the article data.
"Scale above max. load" The weight value is higher
than MAX +9e.