Biotek MicroFlo select, Operator'S Manual

Page: 41 / 130

Repacking and shipping the MicroFlo
|
23
MicroFlo Select Operator's Manual

Remove the tubing cassette.

Disconnect the prime trough drain tube.

Install the shipping hardware (as described below).

Use a rubber band to secure the Pump Cover in place.
Illustration 1

Place the foam pad into the inner box.

Place the dispenser into the foam bag and then into the inner box.

Slide the box insert in behind the instrument.
Illustration 2

Place the upper shipping insert into the inner box.

Securely tape the inner box closed.
Illustration 3

Place the eight foam corner blocks on the inner box.

Place the inner box (with corner blocks) into the outer shipping box.

Securely tape the shipping box closed.

Record the RMA on the side of the shipping box.
Install the Shipping Hardware
After removing the cassette and the drain tube, you can install the shipping brackets.
Two shipping brackets and a rubber band protect the MicroFlo during shipping.
Installation instructions advise attaching the shipping brackets to the back of the
dispenser. They should be screwed to the left back corner of the MicroFlo. Contact
BioTek Customer Care if you need replacement brackets.
Figure 12: Shipping hardware stored on rear panel.
Plate carrier shipping bracket
Dispense arm shipping bracket