Bennett HIGH FLOW H35, Instruction Manual

Page: 31 / 98

Installation
Bennett HF H35 Instruction Manual 27
FINAL INSTALLATION CHECKLIST
The Final Installation Checklist must be completed to ensure a successful and safe installation that meets Bennett’s Limited Warranty
requirements.
Completed √ Item Procedure
☐
1 Verify that all hydrogen fittings are tight and not leaking.
☐
2 All hanging hardware must be checked for proper installation and no leaks.
☐
3 The units must be properly bolted to the island.
☐
4 Vent line must not contain vapor traps.
☐
5 Electrical field conduits must be properly potted per local, state, and national codes.
☐
6 Equipment must be installed in conjunction with an emergency power cutoff to remove all power from the
equipment in the case of an emergency. Test this system for proper operation.
☐
7 All grounds must be properly connected per the installation manual requirements as well as local, state, and
national codes.
☐
8 Use of properly sized neutral breaking circuit breakers for the units involved.
☐
9 All dispenser electrical power is wired to the same phase of electrical power.
☐
10 Use 2 wire shielded cable or 2 wires together for the card reader RS-485 communications circuit.
(Bennett highly suggests that these should be twisted at least 3 times per foot.)
☐
11 Use 3 wire shielded cable or 3 wires together for the Fuel RS-485 communications circuit.
(Bennett highly suggests that these should be twisted at least 3 times per foot.)
☐
12 Use 2 wire shielded cable or 2 wires together for the PLC RS-485 communications circuit.
(Bennett highly suggests that these should be twisted at least 3 times per foot.)
☐
13 New site wiring must be megger tested. Pull new wires in conduits in existing installations.
☐
14 Verify the correct brand panels, nozzles, and hoses are installed for each grade.
☐
15 Verify that all valves are in the proper position.
☐
16 Calibrate the meters. Refer to the Operation section for more details.
☐
17 Close and lock all dispenser covers, panels, and doors.
☐
18 Verify that standard bolts have replaced the eyebolts used for transporting the dispenser.